1-3-2-4

I did this same thing.. I was like wtf I ben't it out of the way but it's still rubbing that's when I looked at the other side and that's when I got pissed.

Nice! I never knew that was possible

Speaking of AC Compressor.. the bracket under the AC compressor can the bolt be installed with those hard lines in the way? I can't for the life of me install the bolt that goes under it so my belt always has slack on it so it squeals.

Mine is still holding up well

Nice find! I bet for us as well same issue.. I've had mine get stuck half way between the front defrost and the vent.. and after awhile it will switch over.. or as of right now it wont switch to floor only at all which is kinda what I want after spending 12 hours at work I saved that video

sometimes in the morning when cold my passenger side wont fully go over to 85 it scared me because I felt the coldness and I looked right over to my temp gauge and I thought I had a air bubble. But yeah I have a issue with the floor and the passengers side sometimes, but I will be taking care of that at a later time not going to focus on it too much right now.

how much it cost to have it painted?

Why would it be the exterior handle if it's a part on the inside?

No no.. not the outside but something fell on the inside of the door that attaches to the door latch so when you try to open from the outside it's like a child lock but from the outside.. it still opens fine from the inside. lucky for me I will be replacing the rear door speakers so I will pull the door panel off.. I get off work around 6 Pm so I wont have any time to do so until the weekends.

I went to open it and I heard like a snap it opened but when I closed it something fell on the inside of the door now it will no longer open from the outside now.. has this happened to anybody before?

My car does this too.. before it went down I don't remember it trying to do so before.

I found it with the circuit tester.

I was looking at adding roof racks to my sedan but the price turned me off

What harness works to plug in the stock connector so I can use the factory wire for aftermarket speakers?

But that brand new car is just going to be a POS to them anyways..

That's what I was looking at too.. crazy.

lol $256 for the oil cooler hose?

I was going back and forth with the nameless plus custom or the HKS silent hi-power and I keep coming back to the Hi power it looks neat and tidy The PO installed what looks to be some ebay axleback and the drone and the rather lack of a deep tone drove me nuts I can't wait to change it in a few months hopefully.

So the reverse wire is in the passenger side kick panel I assume a tester was used to check whatever had 12v to it when in reverse?

Ok just making sure I can't wait to do the suspension next

You got two of the same part number? I thought the l&r had different part numbers?

I had to change my passenger rear like 3 years ago in the dead of winter with snow on the ground must of been like 24F outside Good to know the fronts are better!

The front wheel bearing is it easier or harder than the rear?

I saw this post when you posted it but I'm still confused about this conical adapter.. is this something I need to put on the ball joint or no?

My mom has me car shopping again she had a 08 TriBeCa before and she's looking at a forester but still onto the forester.. I drove it more then her but the gas range and mpg was horrible.. and I ask her why would you get the car again when a new model is going to come out..