**SOLD** San Diego: WPC Treated Outback XT 5MT, R160 Diff, ACT Lightweight Flywheel, Spec Stage 2+ Clutch, Other Outback Bits

[samuel082799]

I Just did a 6 speed swap into my 2005 OBXT so I'm getting rid of some of the old parts. I would like to try and sell the transmission locally so i dont have to ship it.

The transmission had ~180k miles on it, i turned the power up a bit too much and lost 3rd gear. I decided to rebuild the 5MT so i could still enjoy my car while i saved up for the 6 speed swap. When i rebuilt it i replaced 3rd and 4th gear and had 1st through 4th including the main shaft WPC treated to increase the strength of the gears and to reduce friction. I also replaced the main bearings on the drive/ main shaft. For having 180k miles everything in the transmission looked brand new. before i blew it up everything shifted good, no grinds or pop outs. After the rebuild It shifts even smoother from the WPC treatment and has since been proven at 380whp no issues. I have about 3k miles on the rebuild. Transmission also comes with some custom blast plates that i made, and a torque solutions solid brass shifter bushing. I also made a youtube video of the transmission rebuild: 

The transmission price includes the rear diff since the final drive is 4.44 its a bit hard to find the matching R160. I will also include the Group N transmission mount. I have no idea what to ask for this setup since there is nothing else like it out there so I'm asking $1500 OBO SOLD

ACT Lightweight Flywheel ~15k miles (Great Condition) SOLD

Spec Stage 2+ Clutch ~15k miles (Ok condition) SOLD

Outback Rear Axles Miles Unknown (Good Condition) $50 OBO

Outback Driveshaft 180k miles (Good Condition) $150 OBO

I have a lot of other miscellaneous parts from the swap, like shifters linkages, outback crossmembers, and much more so just ask.

Edited March 31, 2023 by samuel082799

[Febreze Mee]

Wow! I just watched your rebuild video last week. I'm putting in a new long block and have a spare 5MT that I wanted to inspect before putting it in with a brand new motor. You're video was a wealth of knowledge! I hadn't made any progress towards opening up my spare, but it's convenient that you're posting this up at the time that you are. Pending the condition/cost of repair, I might just get into contact with you if this doesn't sell, and if you open your options to shipping (buyer paying freight obviously). 

[xrayspecs]

might be intrested in this, semi local, my 5 speed input bearing has started to hum noticably on cold starts. 

whats the rpm sit at when cruising at 75/80 mph with the 4.44's? 

 

[samuel082799]

I would cruise at 80 mph and rpm would be around 3300 if I recall correctly. It gears out at 140.

[xrayspecs]

whats the case code? 

[blackobxt]

I actually hit you up on the tube recently asking about tire size and if you were on the forums. When’s that 6sp swap video coming?

[samuel082799]

18 hours ago, xrayspecs said:

whats the case code? 

I will try to get that number for you later today

2 hours ago, blackobxt said:

I actually hit you up on the tube recently asking about tire size and if you were on the forums. When’s that 6sp swap video coming?

I remember! I've been very busy with school and work so I haven't had time to edit and upload the 6-speed video yet so I'm not sure at this point. Hopefully by the end of the month but we will see.

[samuel082799]

On 3/13/2023 at 7:34 PM, xrayspecs said:

whats the case code? 

The case code is TY757VWAAB