evo171 Posted February 16, 2016 Share Posted February 16, 2016 I wasn't sure if this was just the lighting or if there was a colour difference. I know some parts it's possible to buy unpainted and get a local crash/paint shop to colour match it to your car. Sent from my iPhone using Tapatalk Will need a car wash and and retake at open area to determine. Link to comment Share on other sites More sharing options...
Goliath Posted February 16, 2016 Share Posted February 16, 2016 http://i66.tinypic.com/2n84k1t.jpg Love it! Looks great! Link to comment Share on other sites More sharing options...
leumaskrap Posted February 17, 2016 Share Posted February 17, 2016 Got the bumper, garnish and tower bar installed. So yeah took me a few hours as i have never worked on cars in my life before this. Here are some tips. Subaru - 91112 GARNISH, TRUNK 1: Make sure you get the 2 bolts next to the lights on the left and right side of the trunk, its hard to see and hidden behind a small panel. 2: After getting all the bolts the panel just pulls out as its just clipped in. (Don't be scared!! Yank that thing out!) 3: I could not get the trunk release button out of the original hole on the garnish as its just big enough for the button to clip in. so i had to chopped it (no boot release until i solider that bad boy up. Subaru - REAR BUMPER SKIRT 1: Make sure you pop out the black clips on the bottom of the bumper before putting the new one on, the holes on the skirt will match with the pre-drilled ones on the original bumper. 2: Get it straight! i had a mate to help me put it on and it took us 3 attempts before getting it on straight and by then the 3M sticky tape on the back was not so sticky.... 3: There will be a hole for a screw near the wheel arch on the new skirt and it will match a pre-drilled hole on your original bumper, there is a small plastic clip that comes with the install packet you need to clip it on to the original bumper behind the hole on the new skirt, that piece will give the screw something to thread into. STI FLEXIBLE DRAW TOWER BAR(SG517AL100) Just put it on...... So yeah only got this far tonight, tomorrow will be the front under spoiler. that's going to be alot more fiddly as there is no pre-drilled holes on the bottom of the front bumper and all that it comes with is some random stickers and no instruction. May I ask how much it came out to be in total? Link to comment Share on other sites More sharing options...
Yoda_One Posted February 17, 2016 Share Posted February 17, 2016 :smile2: Laughing at Oneself and with Other is good for the Soul Link to comment Share on other sites More sharing options...
Grnlantern1 Posted February 18, 2016 Share Posted February 18, 2016 May I ask how much it came out to be in total? [emoji387] [emoji387] [emoji387] [emoji387] [emoji387] [emoji383] [emoji383] [emoji383] and Change.. That's How Much I've spent and still waiting for my parts.. Got mine shipped by boat so it's taking forever... [emoji35] [emoji35] [emoji36] Sent from my SM-N900P using Tapatalk Link to comment Share on other sites More sharing options...
ozmikeli Posted February 18, 2016 Author Share Posted February 18, 2016 About $3000AUD or half a days worth of watching the ASX Link to comment Share on other sites More sharing options...
evo171 Posted February 28, 2016 Share Posted February 28, 2016 Finally got around to better pic. http://a64.tinypic.com/n4e63q.jpg http://a67.tinypic.com/n9aox.jpg Link to comment Share on other sites More sharing options...
hkshooter Posted February 28, 2016 Share Posted February 28, 2016 ^^^ Looks fantastic! Love white! My dealer didn't have white equipped like I wanted. Or lapis blue for that matter. Link to comment Share on other sites More sharing options...
hkshooter Posted February 28, 2016 Share Posted February 28, 2016 Question: What the thing on the nose in front of the head lamp? Link to comment Share on other sites More sharing options...
Grnlantern1 Posted February 28, 2016 Share Posted February 28, 2016 Question: What the thing on the nose in front of the head lamp? Light Washers Pop up and Spray..[emoji106] Sent from my SM-N900P using Tapatalk Link to comment Share on other sites More sharing options...
hkshooter Posted February 28, 2016 Share Posted February 28, 2016 Light Washers Pop up and Spray..[emoji106] Sent from my SM-N900P using Tapatalk Well I'll be dipped. Where'd those come from? Link to comment Share on other sites More sharing options...
SubieN8 Posted February 28, 2016 Share Posted February 28, 2016 I concur. Looks snazzy! Link to comment Share on other sites More sharing options...
Grnlantern1 Posted February 28, 2016 Share Posted February 28, 2016 Well I'll be dipped. Where'd those come from? Unfortunately it's the Japanese thing again... [emoji36] [emoji36] Sent from my SM-N900P using Tapatalk Link to comment Share on other sites More sharing options...
3.0R-AUS Posted February 29, 2016 Share Posted February 29, 2016 I concur. Looks snazzy! They look cool but I actually found them to be very annoying one day on my way in to work. It was an overcast morning so I had my headlights on. There was a layer of dust on my windshield so I used the windshield washers to clean it off. Got to work and I did my usual quick clean of the front bumper and side windows (my garage is rather narrow & hard to access the passenger side of the car) - yes, I know I'm very fussy about keeping my car in showroom condition at all times. I noticed there were all these dried dots all over the bonnet. "What the hell???", I wondered. Took a while to clean it all off. Was only a few hours later that I realized they must have triggered when I used the windscreen washer - the headlight washers don't have a separate button; whenever your headlights are on, they will automatically activate with the windscreen washer. So mental note - on an overcast day, turn the headlights off before using the windshield washer... Link to comment Share on other sites More sharing options...
TTG Posted February 29, 2016 Share Posted February 29, 2016 Well I'll be dipped. Where'd those come from? All Europen cars have them these days and some had them as far back as 70s.... They are pretty annoying as they mess up the front of your car when used. I either delete them when ordering a car or disable them if they are there. They are useless and I am glad we don't have them. Link to comment Share on other sites More sharing options...
tigger73 Posted February 29, 2016 Share Posted February 29, 2016 Yes though they are a legal requirement here when your car is optioned with bi-xenon or LED headlights. I think it's something to do with glare from headlights on salted roads... anyway something that we here are almost never going to experience but we get our cars all messed up from the crappy sprayers. Fortunately I got the base model without the fancy headlights - only one time I'm happy I didn't go for the upgrade Tigger73's MY15 2.5i build Link to comment Share on other sites More sharing options...
evo171 Posted February 29, 2016 Share Posted February 29, 2016 Yeah I find them annoying too. They activate when you hold the spray for more than 2secs. So have to do a few short burst to avoid it... Link to comment Share on other sites More sharing options...
TTG Posted February 29, 2016 Share Posted February 29, 2016 Yeah I find them annoying too. They activate when you hold the spray for more than 2secs. So have to do a few short burst to avoid it... They only come on IF your headlights are on, so I usually dim the lights while using the spray and turn them back on again.... That usually solves the problem. Link to comment Share on other sites More sharing options...
diesel4982 Posted March 8, 2017 Share Posted March 8, 2017 I do think the Cusco Rear Strut Bar helps though.. and it's only 180.00.. I installed it and felt the Rear was a Little more solid in Corners less body flex.. http://uploads.tapatalk-cdn.com/20160211/d63b207f0895d6cf034ab620fac4eaca.jpg Sent from my SM-N900P using Tapatalk Do you happen to know the part number to the cusco rear strut bar? Was there any modification you had to do to get it to fit. Link to comment Share on other sites More sharing options...
au_liberty Posted April 6, 2017 Share Posted April 6, 2017 Subscribed - will be ordering all the parts you have ordered! Thanks for the guide! Link to comment Share on other sites More sharing options...
Humble Rumble Posted April 7, 2017 Share Posted April 7, 2017 This looks really great. Nice to see more options cropping up for the 6th gen. 2012 Legacy 3.6R Build Thread 5th Gen Legacy BM/BR Body Kit Compendium Thread Link to comment Share on other sites More sharing options...
au_liberty Posted July 5, 2017 Share Posted July 5, 2017 After much enquiry I finally got an answer from a local dealership. Subaru Australia want $1,500 for the Rear Under Spoiler painted and fitted. Damn.. can't really justify those $$$ Sent from my SM-N920I using Tapatalk Link to comment Share on other sites More sharing options...
Grnlantern1 Posted July 9, 2017 Share Posted July 9, 2017 Do you happen to know the part number to the cusco rear strut bar? Was there any modification you had to do to get it to fit.I've listed the Part Number in trhe Modified Section of the Forum but look on the Cusco Site for a B4 Rear Strut Bar the 2010 and Up Rear Chassis is the same as the Gen 6.. You have to trim the Flooring just a little where the Bar Bolts in.. Simple Stuff.. Hope This Helps..[emoji106] Sent from my SM-G955U using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.