Jsmith Posted September 12, 2017 Share Posted September 12, 2017 So I have not attempted the install, nor looked at the wiring into the headlight yet. From searching on here, I have read that two wires connect each turn signal socket. I already have the LED bulbs and Sylvania resistors. My question is this, how do I wire the resistor? Do I bridge the hot & ground wires? Do I connect the resistor directly to the + wire twice? May seem like a dumb question, but I really don't know. When I did the DD turn as tail kit, the resistor was already wired into the harness, so I just plugged it in. As always, all advice or photos of your wiring is appreciated! Link to comment Share on other sites More sharing options...
PATS4LIFE Posted September 12, 2017 Share Posted September 12, 2017 Just bridge resistor one end + and other end - Link to comment Share on other sites More sharing options...
testa422 Posted September 19, 2017 Share Posted September 19, 2017 why bother with resistors...just replace the flasher module with one that is compatible w leds. problem solved you can now add led bulbs to the turn signals with no issue. can also mix n match led and regular bulbs if you so choose Link to comment Share on other sites More sharing options...
Jsmith Posted September 19, 2017 Author Share Posted September 19, 2017 We don't have flasher modules in the 6th gens. Its integrated into the BIU. Link to comment Share on other sites More sharing options...
testa422 Posted September 19, 2017 Share Posted September 19, 2017 We don't have flasher modules in the 6th gens. Its integrated into the BIU. ahhhh...learn something new everyday. ill go back to my 5th gen corner Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.