r31oh Posted September 2, 2016 Share Posted September 2, 2016 anyone know the socket size for the pinion flange nut on the rear diff? Ive been searching for it, but all I can find is the torque specification Link to comment Share on other sites More sharing options...
rougeben83 Posted September 3, 2016 Share Posted September 3, 2016 IIRC its 21mm or 19mm... Link to comment Share on other sites More sharing options...
Max Capacity Posted September 3, 2016 Share Posted September 3, 2016 http://people.csail.mit.edu/ilh/vacation/ Look up around page 4000 or so. I currently have the rear diff section printed out in a binder sitting on the passenger seat in the wagon. But I'm sitting at my desk at work... sorry. Oh just noticed you have 1996 ? In the top of the Gen Chat forum is a sticky about "vacation Pic's" you'll find links to the service manual's. 305,600miles 5/2012 ej257 short block, 8/2011 installed VF52 turbo, @20.8psi, 280whp, 300ftlbs. (SOLD). CHECK your oil, these cars use it. Engine Build - Click Here Link to comment Share on other sites More sharing options...
r31oh Posted September 4, 2016 Author Share Posted September 4, 2016 yea its a 96, but the tranny and diff are from a 97. I have a Haynes manual for it, but it didn't give a nut size. My socket set goes up to 25mm and that was too small, i might just go get another socket set lol. i have another project that requires a 30mm socket. Link to comment Share on other sites More sharing options...
r31oh Posted September 5, 2016 Author Share Posted September 5, 2016 its a 27mm!!!!!!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.