madrig

happy christmas

i really like what i m seeing on here !!

if anybody need guidance or need more info dont hesitate to cantact me !

you will need to extend the bumper to match the quarter . you can do it after the install of the quarter . yes i sell the corner piece with the quarter .

for bonding the panel i used 3m epoxy glue 08115 , it is available in most small store and supplier and the quality is very good . there is other that i use , devcon or sci grip but is more expensive and not available to everybody . dont forget since some place will be barre metal after preparation to coat any place that will not receive glue , it will rust and cause later problem . you will need to reuse the lacht bracket . remove it from the metal panel by drilling the spot weld and bond it with epoxy on the new panel . when bonding be sure you keep the ajustment play of the nuts . there nothing particular in order to bond the panel . the panel align itself , just double check the door gap and respect the over lap bond on C and D pillar .

in order to replace the quarter panel you will need to remove rear bumper side skirt wheel guard tail light , plastic cover , seal , disconnect gate shock . inner trunk carpet , inner side cover . rear sill door , rubber trim . exterior trim window guard and removal of the rear quarter glass . most difficult is to remove the rear glass . the glass is made with exterior trim as one piece . you need to acces by inside to cut the seal and is very far inside . also plastic pin for install are there and will be cut same time as the seal .

of course you need to remove you metal panel ! the end of the pillar of the composite panel is made to overlap the metal pillar , so do the cut under the overlap. make blank prefit before bonding . you can not really place it wrong ! follow of the oem points for guidance .

the piece

this thread is for information on installation of the legacy wagon quarter panel composite extended . so why wider fenders ? the look is definitely attractive in most case but this idea was guided by functionality. my car is not a garage queen , so it need to perform , in all weather and on some horrible roads . but we all can say this is an equation of desired stance , wheels availability and functionality. the wheels specs for start . to understand correctly , the rear fender are wider in the rear as oem spec , so i extended fender to be equal front to rear. the front was extended 30 mm and the rear 20 mm . so 20 mm to rear dont seem a lot but it is . with the composite panel you saving the roll edge so you can be flush with the panel .

the plug

an other of my idea . i changed the fog light ! i used ford led fog, valeo made , that are the same as 5 gen legacy and look the same as the morimoto xb aftermarket fog . the idea was to find a model widely available .i will also update this to my post facelift jdm bumper cause there is chance i make a mold of it , so the need to supply with fog light at good price .

but finally i think is ok , i get use to it and i m glad i tried something !

so i smoked the flasher . a little bit too much too my taste . compared to my backup light and rear spoiler light .

but i dindnt really like it at first i removed the black trim that some designers in japan took time to design !

so i did a thing ! i always do stupid thing and i always got carry away with ideas. . seeing the fade on the exterior mirrors and my passion for painting i ended up painting all the parts ! i m incontrollable with a spray gun !!

you can see what the bumper is extended and the room you gain

even if i sell the all piece that fit on top of the bumper i only use the small triangle piece that i blend to the bumper is up to you to use the all piece as a ad on or blend just the small corner section.

do not forget the front bumper extension to match the fenders

i got rear ended ! but just the gate was touch . my car is low and the suv bumper just sat on my licence plate . bumper , quarter panel , tail light are safe !

i did some modeling las week ! very productive work !

somebody say carbon !!