testa422

do not buy cheap amazon leds

im going to get flamed but in my opinion these are TRASH. get some Baja design or diode led fogs if you actually want light output

if you arent interested in power fold like myself, I just ran the signal wires through the door loom and then up into the engine bay where I tapped the front signals for power. Youll obviously need to extend the wires for this method though

16000?? hahahahahahaha

had 102k when it started

the shuddering and grinding noises are literally the most common signs of a CVT failure...its on its way out without question. Ask me how I know as im te owner of a 13 with a fukked cvt

i had the subaru option rear spoiler, rear lower lip spoiler, cyber r hood scoop and liberal bonnet spoiler on the car and had the carazon front bumper/grille/hood/side skirts and rowen rear bumper on order before my car shit itself. as corey said, it will be VERY expensive as the parts i had on order were roughly $4500 including shipping...before paint and install

to be 100% clear, those are purely Rowen...TommyKaira didnt authorize their name to be used for any of this

i had multiple sets of the Liberal gauge overlays...quality and fitment are top notch as to be expected...only issue as stated is theyre LOOONG discontinued and read in KPH...aside from that, they were a welcome upgrade

sounds like shitty cheap LEDs

Correct. Pry it out. You found a light from liberal on rakuten?

Just went outside to do it. LED is top dead center right in the front of the glovebox. Pry it out, swap unit, put back in. 15 seconds

Yes just let it out. You swap the whole unit as a piece. Unplug it and plug the new one in. No need to disassemble glovebox. Literally takes 15 seconds

$49 shipped to my door in NC https://www.japanparts.com/parts/detail/46452

yes...just pull on it and it pops out. very similar to the door lights. was literally a 15 second job to swap

you dont have to do any of this...you just open the glovebox and the led unit is right on the top

valenti and liberal, both japanese companies are the only ones that make this replacment as far as i know. be prepared to spend in the $50 range for it

read it just fine...seems useless still as with most of the shit youve posted but hey

so if you know how to do it, whats the point of this thread? do it yourself and let the dealership rape someone else

i have used partsouq but shipping was stupid slow and they really only have oem replacement parts...not so much aftermarket stuff

it wont cause any harm to anything except your wallet....

vleds are the best on the market hands down...HIDs are good as well as long as you buy quality and not cheap chinese shit. also, i have personally tried vleds, morimoto, diode dynamics, stark, coofix and lasfit leds in my legacy and even in my current car. VLEDS are the best of the best and i ran them in my legacy for well over 5 years without a SINGLE issue

yahoo auctions...croooober....farpost.ru

Can’t wait for the blitzen

Can’t wait for the blitzen