srz Posted July 11, 2021 Share Posted July 11, 2021 greetings. the code says iacv failing. idle very low. 96 subaru outback. 315k miles and still rambling along. iacv failure has added a bit of rumbling, as well. question, please. i watched a video from wisconsin. the fellow revved the engine to 2k rpm, then removed a hose and poured in a bottle of sea foam slowly. lots of smoke. ten minutes later the engine seemed to be running very well. can anyone else recommend this method? it seems a lot easier than manually taking things apart and a replacement for my legacy at autozone seems to be about $400! thanks for any help with the cleaning of iacv question and best wishes. Link to comment Share on other sites More sharing options...
Brighton96 Posted July 11, 2021 Share Posted July 11, 2021 Sea foam is awesome stuff so I trust it but have never used it in that way, the closest method I've used it for is pouring it into a vacuum line with the car running to de-carbon the intake manifold/valves. It's also pretty easy to remove and clean the IACV. 2 10mm bolts, 2 coolant lines and the vacuum line, also have a new gasket ready to go for install. There's a good chance the old one won't be usable again. Link to comment Share on other sites More sharing options...
doublechaz Posted July 12, 2021 Share Posted July 12, 2021 This procedure is in the FSM. They call out ACDelco Upper Engine and Fuel Injector Cleaner. I have the bottle of stuff, but I have not performed the procedure. I have not used SeaFoam either. I don't know the contents of either product. Link to comment Share on other sites More sharing options...
srz Posted July 12, 2021 Author Share Posted July 12, 2021 thank you very much, doublechaz and brighton96, for your advice. Link to comment Share on other sites More sharing options...
Leggyobw97 Posted July 14, 2021 Share Posted July 14, 2021 Do yourself a big favor and remove your O2 sensors before doing a seafoam treatment, unless you want to replace those too. Link to comment Share on other sites More sharing options...
Brighton96 Posted July 14, 2021 Share Posted July 14, 2021 Do yourself a big favor and remove your O2 sensors before doing a seafoam treatment, unless you want to replace those too. I've actually never heard of doing that but makes sense on paper. I've done that treatment about a hundred times and haven't had one die on me, maybe luck, I dunno. Link to comment Share on other sites More sharing options...
doublechaz Posted July 15, 2021 Share Posted July 15, 2021 Maybe it's different for narrow band vs wide band. I'll be sure to take out my wide band and pop in one of my working pull narrows if/when I do this. Just to be sure... Link to comment Share on other sites More sharing options...
Leggyobw97 Posted July 15, 2021 Share Posted July 15, 2021 I've actually never heard of doing that but makes sense on paper. I've done that treatment about a hundred times and haven't had one die on me, maybe luck, I dunno. Yeah I had to replace one the first time I did seafoam on my 97 OBW, due to carbon build-up on the sensor. Maybe my engine was dirtier than yours and sent more soot out the tailpipe. Either way, removing the sensors definitely removes the risk of fouling them up during the treatment. Heard a lot of people call seafoam "opening up a can of worms" and that's one reason why. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now