kalabala2005 Posted February 25, 2018 Share Posted February 25, 2018 hello please advice when i change mode to another mode ( i hear tic-tic-tic ) and nothing happen ? if it Vent Mode Actuator where its place and what is the Actuator should i replace as i know there are 4 Actuator on my car and can i do this by myself or no ?? as attached pic is the vent mode mixer is NO 7 ? on second attach and what is part no for it as i must buy it before doing anything ?? Link to comment Share on other sites More sharing options...
kalabala2005 Posted February 26, 2018 Author Share Posted February 26, 2018 Why no one answer me Link to comment Share on other sites More sharing options...
Shadow_419 Posted February 26, 2018 Share Posted February 26, 2018 Why no one answer me It's been one day since you posted. Perhaps no one has any experience with these vent motors. I don't know anything about them. Link to comment Share on other sites More sharing options...
FLlegacy Posted February 26, 2018 Share Posted February 26, 2018 I would watch the actuators and see which one doesn't move, then get out a multimeter and see if its getting power/signal to move. Then go from there. Link to comment Share on other sites More sharing options...
Brunzo Posted February 27, 2018 Share Posted February 27, 2018 It's a common issue on BM/BR series when the motor is stuck or lube is dried. Please check at dealer, these were replaced by dealers in terms of Goodwill. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.