BoxerLove Posted February 18, 2015 Share Posted February 18, 2015 So yesterday i finally got sick of the ugly green very dim gauges. I have a whole roll of led's laying around so i started a little project. Now the gauges look awesome, but when i pulled the RPM needle out the first time it came off very hard. I placed the needle back on and realized i probably should have waited to do it in the morning when i could set it at a speed i know the rpm range of. Was going to use 70 MPH which is roughly normally 3000 RPM. I pulled the needle off but this time the pin it slides onto came with it! I tried pushing it back in but it wont go back in. Any help here? Link to comment Share on other sites More sharing options...
Tr00b Posted February 25, 2015 Share Posted February 25, 2015 Yikes I am not sure what to do there! I do have two spare clusters though if you need parts. I have one with a busted speedo needle that can be yours. Make me an offer via pm if you need it. Link to comment Share on other sites More sharing options...
taylormac1993 Posted March 3, 2015 Share Posted March 3, 2015 Wow what LEDs did you use? I used some bulbs from superbrightleds but they are, ironically, not even close to super bright. Did they just pop in like stock replacements or did you do some fabrication to get them in there? Sorry to steer your thread in another direction, I just had to ask haha. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.