BigBad

I am way past warranty work at this point with over 100k on the car. They refer to it as the roll connector. Cost me about $200 to have it replaced.

I had the dash airbag light come only from time to time only. Turns out it was the steering wheel harness that was the problem and had to be replaced.

I checked mine a little while ago and had no chafing or any damage. I did wrap each side bundle of wires up with electrical tape to give them some added protection.

I will have to check this out on mine.

Red '05 wagon with aftermarket grill, side front license plate mount and tints behind me on rt 117 in Bolton near Rt 495 heading toward Stow just before 5 pm today. Waved in the rear view mirror.

Very Neat!

Raccoon eyes I'd say...

If a cop saw you doing it I bet he'd pull you over but I have to say I think its going to be a tough law to enforce the for the texting portion.

Oh cool. My folks are on Reservior drive a couple houses down from the town center. Bill

Sounds like me. My daughter and I were heading south after spending a week on at my folks place on lake Deering. Yours was a DGM sedan if I recall?

I just got mine inspected, no problems running my Greddy sp2 catback.

That looks amazing. Very nice work.

This morning about 8:40 on Rt 62 in west concord just before Rt 2 came up behind a black legacy sedan and a black GT wagon pulled up behind me. You both headed east on Rt 2.

subscribed

Thanks. Yeah that was me heading to work. I saw you too and gave you a wave in the rear view mirror as I turned right and you went straight. Mods include: Greddy SP2 catback Cusco sways, Cusco under bracing, plus AVO components Kartboy STS, upgraded bushings, trans mounts, Casopolis shift knob HPS pads R-Rev sport grill, V2 headlight eyelids Stage 1 with aftermarket tune

Yeah that was my car, dropped it off this morning for some service work.

Gotcha.

Yeah that's my car. I work at Hologic. Were you just passing through or did you have business there?

I do for a short distance getting on at 2A and get off on Rt 3 north and the reverse going home but was not there today.

Counting the days....

Kartboy with the complete hardened bushings package from Turninconcepts, is what I have and it performs really well. I also recommend Prothane grease from Jegs used for lubing polyurethane bushings which works really well here for lubing the base of the shifter, pivot point and underneath at the rear stay bushing. Its water proof, and very sticky.

Subscribed. Very interested...