Jump to content

raderwerks mten 80 et35


Recommended Posts

What do I have to do to make these bad boys fit roll & pull fenders? They make them in et35 for our 5x100 bolt pattern but et 45 for 5x112 fudge! If I could get em with a et45 then I would run 18x8 cause there would be no need for fender work but I have to pull/roll it anyway so i'll go for 18x9! So what do you guys think about em, I think they would look bangin on my BSM...
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

Terms of Use