Jump to content
LegacyGT.com

License plate nuts on 2008 Legacy


Recommended Posts

Hey group,

 

I bought a 2008 Legacy last month. I was putting my plates on today, and the guys at the dealership overtightened the brass screws that hold the rear dealer plate on. As a result, the white captive nuts just spin inside the trunk lid.

 

The dealer used a drill on the top two screws/nuts. They didn't touch the bottom ones. As I was putting my plate on with one of the top screws and a bottom screw, the bottom nut started to spin after I was only about halfway into it. Totally lame....

 

I had the dealer order a new set of them. Anyone else had this problem? Other than that, I have no complaints about my Legacy 2.5i Ltd... except the transmission is kind of slow at time, such as when you floor it around 25 mph, there is an uncomfortable delay before the engine speeds up.

 

Andy

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

Terms of Use