apokalypse Posted February 5, 2017 Share Posted February 5, 2017 Is there a recommended seated depth for the output shaft seal? I didn't take a photo of where it was installed to before pulling it out. I can see some of the sloped edge... just wondering if the seal will bottom out when it's "far enough". Link to comment Share on other sites More sharing options...
apokalypse Posted February 6, 2017 Author Share Posted February 6, 2017 This is what it looks like seated right now... I'm not sure if there's supposed to be that gap between the seal and the other portion(back of the bearing)? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.