tlsonline63

thanks FL! that makes sense should be easy to do that way. unfortunately I'll be on my back wishing I had a lift.

drivers side seal, it started leaking a couple weeks ago. Cleaned up all the mounts and drove it a little bit the drivers side seal area was "wet". Below the mount, passenger side and was dry. Then had the service guy check it while I was getting the oil changed. It was low so they topped it off and now there's new puddles. Will get in the air and check again this weekend.

I have 3.6R limited, CVT with the rear diff leaking and trying to figure out how much work it is to pull it and replace the seals. I haven't found a good video yet, or forum showing the basic steps to see if I want to tackle this my self with the car on jack stands. wondering if I have to pull both wheels/axles or if there's a way to drop one side and do it in place or does it come all the way out. While I'm there should the rear mounts be replaced? if you have any good links that show the basic steps I'd appreciate it or have any tips, gottcha's to look out for I'd appreciate that. Overall it doesn't look too bad 4 bolts on the drive shaft, 4 mounting bolts and the cv joints. diff is marked: VA2RGT-XC on one side f the cover and 833206 on the other. thanks for the help. For what its worth I'm a rookie dealing with CV joints and driveline stuff. I've done brakes, plugs, alternators, starters etc.

did you find a good suby mechanics? Looking for one....