StrongestAvenger

success! i can finally see the things i want to see! thanks again solidxsnake!

thanks for the help man, I have spent months trying to figure this out. on the bright side, I feel i have a way better understanding on the matter. time to flash, log to make sure things are gravy then time for a tune! also just realized i made a mistake, the file his link downloaded was a .hex file

would that be flashing the .xml that dschultz had in his last post to my ecu?

Thanks for the help solidxsnake. i found that thread last night after you pointed out i can see the ecu id in the lower corner. So I need to swap A2WC521S with A2WC522S. Now i just need to figure out where and how to do that

I deleted those two out of the program files and removed them from the editor. I re downloaded the .zip files and tried extracting them in a folder on the desktop then went into the managers and referred them both to that folder and had the same results. Ecu id is 2f12795506

Ok just to clarify my process for installing the editor and logger Downloaded: ecu_defs.xml rommetadata.zip and logger_STD_EN_v346.xml 1. Went to (x86)\OpenECU\EcuFlash\rommetadata and copied ‘read templates’ and ‘Subaru’ to a folder on my desktop 2. Extracted rommetadata.zip to (x86)\OpenECU\EcuFlash\rommetadata clicking ‘replace’ for all files 3. Moved both ecu_defs.xml and logger_STD_EN_v346.xml to (x86)\RomRaider 4. In rr editor definitions> definition manager >add: C:\Program Files (x86)\RomRaider\ecu_defs.xml apply and save 4. In rr logger settings> logger definition location> add C:\Program Files (x86)\RomRaider\logger_STD_EN_v346.xml 5. Close and reopen. Go to logger, vehicle connects and reads data but not all and when I try to go to the learning table values I get the error: “ECU definition file not found or undefined” I tried uninstalling and deleting everything then downloading and reinstalling everything I get the same results. SolidxSnake, I saw your post on RomRaider forums and yes it does see the car and no I don’t care about the virtual dyno

Finally had a chance to try running it again and I am missing a ton of parameters and when I try to go to the learning table values I get the error: “ECU definition file not found or undefined” I’ve clearly set something up wrong . The cars a 2005 outback xt 5mt if that matters

Only with the logger

Posted this in tuning, Hey guys, this is more a desperate cry for help than anything. I’m trying to set up the logger and when I open the program I get the prompt: cars definition file not found I downloaded logger_STD_EN_v346 and went to the logger settings>logger definition location and chose logger_STD_EN_v346. I still get this error code and I can find lids that I want to log like feedback knock and fine knock. What am I doing wrong?

Hey guys, this is more a desperate cry for help than anything. I’m trying to set up the logger and when I open the program I get the prompt: cars definition file not found I downloaded logger_STD_EN_v346 and went to the logger settings>logger definition location and chose logger_STD_EN_v346. I still get this error code and I can find lids that I want to log like feedback knock and fine knock. What am I doing wrong?