TylerHartman

Now here's the spice

 

Got a big order from a dealer in japan right before covid got EMS shutdown

Re wrapped my Spec C Long runner Intake wiring harness (deletes TGV Plugs)

Got my V8/V9 Long runner coated along with APS Parts

Figured you know with No car meets or anything wildy fun to do.. May as well tear this thing down and finally get it done.. so that's what happened

Found the correct tank and rubber hose for v8/v9 tank

Installed the TurboSmart EWG

Replaced all the hoses under the Intake for the most part along with new bolts etc.. Ended up being the right move, Half of the PCV hoses cracked upon removal

These are going to be out of order but here it goes

 

 

Installed Slash Rotor Covers and Spline lug nuts

 

 

 

 

also have my hipposleek/zerosports grill in currently with syms skirts. but they still need paint

 

 

installed a Zero/Sports badge on the M20TB pod

I decided to Test Fit my SYMS Skirts after I got the front lip... Holy crap it looks good

 

APS 70mm Cold Air intake, I love the ARC look. But Pod Filter Succ is amazing

 

APS 3" Inlet

 

 

Got some Esams Turn Signal Mirrors to retrofit on

 

I worked on running the wire and rear tweeters of my second TX65C Kit for the rear. Still haven't wired them in or hooked up speakers

JDM option Tiger stripe mats

Zero/Sports plate frame

 

Ended up getting a hold of my Dream Greddy/Trust Lip for the JDM Bumper (it happened to come pre-painted white, so been running it, temp)

Here are a few pics of the lip with other grills etc I have

Here's the Prova hood lip I also bought

Prova grille

Hipposleek Grille

Nightpager Catch can/Washer tank

Hey! Been a bit since I've updated, just gonna go through it. a lot of this will be out of order

 

Installed the Fluidampr most recently, only had one short drive with it so far. but Very impressed with how it smoothed it out

 

Ordered a Vibrant 18x3 Resonator, Hoping this can solve my tinny raspy sounding exhaust, just hard finding people to do work with the Sickness going around now

 

Gauge pod from a M20tb with Defi CR boost, Defi CR Water temp, Defi CR Oil Temp

 

 

Rare OEM Center Console Power Inverter

 

Black OEM BH/BE Sun Visors

 

Mocked up Spec C Power Steering cooler (not plumbed in yet)

$165

I bought it and never ended up installing it, couldn't say I do know you can't stream audio over Bluetooth on it and that's a shame

180 shipped and will throw in free aux jack

Sold

$180 shipped

V7 STI Power Steering cooler

 

IA Tuning speaker adapters

 

 

Skar Audio TX65C speaker install

 

My old cheap front kenwoods vs these

 

 

 

Tesa Taped the harness's

still love the carbon mirrors with your paint color

P-204UH from 07-09 legacy (Aux)

 

 

 

Asking $200 shipped

P-204UH from 07-09 legacy (Aux)

 

Parrot CK3000 Evolution Bluetooth Handsfree Kit included as well, will need to buy a replacement microphone. but it's a normal style most car radios use so should be cheap and easy

 

Asking $220 shipped

New Wheel! Black Momo BH5

Defi CR Boost

also got all the sensors going on the ZD

Replaced the compass for a Alpine Mini Disk player

found a 207 V8/V9 Long runner with most the hardware needed to install for a fair price

Snagged up a 207 V8/V9 Spec C Theromstatic oil cooler

Rad build!

 

Thanks

Well I bought a S401 BFM

Then started on making it work, first spent way too much time on making a Plug n Play adapter just for it to not work. Don't waste your time, flexible PCB's suck

so bought a pack of Tesa tape, yanked the dash and merged 3rd gen plugs in. turned out amazing and also put some outputs in for some stuff to come

started cutting plastic out next

I plan to fiberglass/Bondo an extension on the top of the shroud to fill the gap as the Audio guys do for speakers in time

no shroud installed at this time, but hopefully, I can mock it back in this week

Tesa tape is sick

Also as you probably have seen, I bought a Defi ZD ClubSport pack. this thing is amazing. gonna install the sensors this week

picked this up for the KM/H to MPH Conversion

Radio in! with Aux Ai-Net cable

Red stitch Ebrake

Sourced BH black Grabs

Knocked up a extension for the Blinky Alarm light so I can get a I/C spray button for dash now

Bought an Alpine PWE-S8 Under seat, in prep I bought supplies. one was Tesa tape, it's amazing. Wrapped a bunch of stuff up under the dash

Also bought some new battery Terminals

 

Very special JDM package inbound this week

Wow nice work

 

thanks

Decided I needed to make work for myself Painted headliner and installed Fiber Optic lights

 

 

Painted Cargo Area, and Installed Cargo fans (mostly)

 

Tested a Little Patch on the carpet, and went well so the whole thing went. but here's a comparison

 

also, sound dampened the floor

Been after an Old school Radio a bit.. (ideally alpine) and this fell in my lap for $14 at the wreckers, spent some time cleaning it up and ordered up an AI-Net to AUX converter for it. I'm in love, even does that 90's/00's Tilt

 

Another item long on my Wishlist was the Rare JDM Optional Cargo Fan, a Russian JDM parts dealer located this for me. The covers are the wrong shade and no wiring harness but I planned to fabric paint my interior carpet back there anyway so no biggy

started fab'ing a harness up (I/C Spray tank and Cargo fans)

Zero/Sports I/C shroud, going to try to open this up some more to fit the 08+ Style I/C better

been sanding on some goodies to get some stuff installed soon

Some Headlight Covers for the Morettes, but test fitted them to the OEM Projectors

JDM Foot well lighting kit

 

Zero/Sports Hard pipe

You need the Kakimoto Race Chamber from Japan. I had one on my 08 2.5i, yes I was tuned for it. I thought it was a myth till I ordered it from japan parts.

 

Actually I am considering doing that, was there noticeable gains with a tune? just not sure it's worth it on a 2.5i auto. but I do like my Bling

 

 

Love the build man! Looking forward to seeing where you go with this.

 

Thanks! Like hearing that from GT/SPECB owners, normally get crapped on for "wasting my time, and money"

Going to be a fun project! I’d just go with a custom up pipe as well, you’ll end up having to swap tons of stuff otherwise and you’ll have more turbo options if you go custom.

 

If your going to that hassle may as well buy a wrecked 2.5GT and go to town, NA-T is better left to be cost effective can’t wait to see updates

 

 

Sent from my iPhone using Tapatalk

STI Front bar

JDM paddle shifters (need to trim the bezel a hair more and wire them in. but did that first leap of cutting to install them)

B-Sport badges (more a less spec-B but N/A, kinda..)

STI Option Pedals & Weathertech floor mats

eBay LED Panels

the dome light is the LG dank

the bad news...Garnish came busted! we'll see what USPS/EMS will do, but this stinks