-
Posts
31 -
Joined
Content Type
Profiles
Forums
Gallery
Everything posted by Apike11
-
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
HR 5025560 Trak+ DRM Wheel Spacer They are 25mm and yes both the same front and back. Was going to go smaller on the front but tested them out and decided I liked it the same. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
I think my favorite thing I have done that could be in that price range would be the headlights. I got mine with HID's so that made then a little more expensive but without that it will be in your price range. Spoiler I would say also, but I have been putting mine off. The Lowes front lip is the cheapest coolest investment I made. It has held up through many snow storms and even when we had so much that I was plowing it with my front bumper. The only thing I would say about it is where it wraps around, just need to put screw and washer set up to push the lip out. I posted previously a while back if you want some ideas of how to do it. Also I like the stock mud flaps if you don't have or if you are running stock rims, H&R spacers are very nice to bring the rim and tire out flush with flares. I have pictures of that as well. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
They are LED Bulbs. Not really for headlight use but my Projectors are BI Level so the lens flips for more light output So my projectors are my highs and lows. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
-
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Very nice, the only thing that I don't like is where the rubber strip folds around the bumper. Check an earlier post. I just put a small bracket underneath to push it out. I think it gives it a much more natural look. Otherwise good stuff. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
10 minutes -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
um yes, I said rubber strip -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Tape is holding it on. But I screwed 2 brackets where the bumper bends around to the wheels. I didn't like how the rubber looked flat in those spots so I made 2 brackets to push it out. I will try and snap a picture underneath so you can see where I pushed it out. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Just finished putting on my new Front Lip. Looks better than I thought it would pleasantly surprised, with the rubber strip. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Nope they are the Subaru ones. They are surprisingly better then I expected. I like them so much that I think I am going to do a underbody led strips and maybe in my grill. We will see. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
-
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
-
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Here are some different angles of the grill (so you can see how black it gets). Also my winter wheels, which sucks because no snow. What the heck NY, where is the snow? -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Agreed nice pictures. I like the last one best!! -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
It is all fibreglass except for wood ring for sub and small square where amp sits. First I pulled out the trunk liner. Then I covered it will making tape. I then put my own trunk liner fabric in the pocket, and put fibreglass resin on the fabric. Once dry pulled it out of the molded liner and now you have the back of a sub box that fits perfectly in that pocket. I did use a little bit of fibreglass mat to strengthen that back piece otherwise I just used trunk liner fabric in place of the mat. Once you have the back down you just put the sub ring where you want it and stretch the fabric tight over the ring and around the back piece. Cover in resin once again. Cut out sub hole which I didn't put resin on so I just used a razor. At this point you can do a light sand and the cover in carpet. Or sand and fill until smooth enough to paint. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
The grill is from eg classic. It comes in 2 pieces. You might be able to just get the lower. Yes I made the box. Thank you. Its all fiberglass. Just took trunk liner and just masked of the molded liner that is already there. Then just painted resin over it. Pretty easy, especailly if you're carpeting it. I wanted to paint so sanding sucks. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Just drilled 2 holes and bolted them on after I used the dremel to shape out the outside corners to get them flush. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
This is also the box I have been working on . Almost done but realized I needed a cap, so that has arrived just trying to place it. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
It was a little dark out. I will try and get some better ones when it is not so dark. The lights in the headlights that are on are led bulbs as well. I couldn't get any good pictures with the hid's on. Hopefully i can do better tomorrow. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
It is an EG Classic grill that I had done over with black chrome. And yes I put the leds in the fog light spot. I got them to fit in so well I decided not to get the actual fog lights. I think the thing I like most about the grill is the lower grill it really fills in that empty space down there. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Yeah I don't like chrome either. It really is black it come out well in pictures. Black chrome can only really be appreciated in person. Or I could learn how to take better pictures lol. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
-
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
http://i11.photobucket.com/albums/a158/apike11/utf-8BSU1BRzAzMDcuanBn.jpg http://i11.photobucket.com/albums/a158/apike11/utf-8BSU1BRzAzMDYuanBn.jpg Just some quick updates. Headlights on from idrvslo .http://legacygt.com/forums/showthread.php/idrvslo-headlight-modification-and-clearing-service-160048.html thank you they came out awesome. Also used a shadow paint on the chrome grill. -
Official Steel Silver Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Its called black chrome. Its a high gloss black which is covered in something to give it that chrome look. -
Official Graphite Grey Metallic Thread (2010)
Apike11 replied to Tide's topic in Legacy Photos (2010 - 2014)
Yes I could but not in black chrome. I already own the only black chrome rims that I liked but they don't fit on this car so my wife got to inherit them. Lucky women.