WahooNo2

i have had these on my car for a little over a month now and they work well. i also had the issue whe the supplied ball joint was a little to big for the knuckle on one side. i sanded it down using an abrasive disk since i had bought brand new knuckes. Also to remove the pinch bolt from the knuckle ... take knuckle off the car, remove or protect the wheel bearing, cut the boot off the ball joint because it will burn and then start heating the bolt up with a torch using map gas for around 3 to 5 minutes. Spritz water on the bolt and surrounding area to cool down. Put the knuckle in a vice and loosen with wrench and pray you dont break it... Assuming you got the bolt out you can easily take the ball joint out with an air chissel by putting the castle nut back on the threads and then using a v shaped chissel to knock it out. Clean out hole, check that the new ball joint fits easily... if not spread gap with a chissel or screw driver.