Mitchael Posted March 2, 2013 Share Posted March 2, 2013 1997 Legacy Outback 2.5 Automatic trans ~200K miles. Every so often it spikes in temp, but a couple mechanics have looked at it, and no one has found a leak. Of course it doesn't overheat when I take it to the shop. Top radiator hose gets hot, so the thermostat doesn't seem like it's jammed shut. New radiator cap. Recently flushed, new fluid. The weep hole on the water pump isn't leaking, so the pump should be fine. The heater blows hot (really hot) and this will most of the time keep the temp gauge at or just above normal temp. The only fluid I seem to be loosing is from the overflow reservoir when the fluid is hot and boiling over. One forum suggested that the heater core may be bad. I was going to bypass it to see if that fixes it, but I'm concerned it won't, as I still get heat and I haven't noticed much fluid loss or any leaks into the cabin. My first 97 Legacy Outback 2.5 overheated like this at ~240K and I got rid of it before I solved the problem. Any suggestions? Is this a frequent thing? Link to comment Share on other sites More sharing options...
monkeyposeur Posted March 2, 2013 Share Posted March 2, 2013 Either your thermostat is not an OEM t-stat, is bad, or your head gaskets are leaking internally. Your heater core being bad or clogged is also a possibility, but not a common occurence. I'd recommend getting a hydrocarbon test done as soon as possible. It will tell you if exhaust gases are getting into your coolant. Is your overflow tank bubbling? Milky? White smoke coming out of your exhaust? Check your bottom radiator hose for heat, not the top. The bottom hose is directly connected to your t-stat. Link to comment Share on other sites More sharing options...
travgag Posted March 2, 2013 Share Posted March 2, 2013 +1 might be a random failure of the thermostat sticking or something, but there's definatly things to check Link to comment Share on other sites More sharing options...
JJay03 Posted March 2, 2013 Share Posted March 2, 2013 Hmm a 2.5 over heating I wonder what it could be lol? 90% of the time its the HG's sorry to say. Combustion gasses can get in the coolant and cause it to have a air gap right behind the t-stat with no noticeable signs of leaks. Link to comment Share on other sites More sharing options...
Scubaru03 Posted March 2, 2013 Share Posted March 2, 2013 I would disconnect the top hose from radiator and make sure the block is full and no air pocket. If not that. I would replace the thermostat. Link to comment Share on other sites More sharing options...
monkeyposeur Posted March 2, 2013 Share Posted March 2, 2013 ^Good call about possible air trapped in the system. I spaced that. Personally I would purge or burp the system before disconnecting the radiator hoses. Link to comment Share on other sites More sharing options...
snederhiser Posted March 2, 2013 Share Posted March 2, 2013 Hello; Are your cooling fans working properly? Head gasket issues usually show contamination of the overflow bottle, brown coolant. The oil can be contaminated, getting brown with a milky white foam collecting on the filler cap. Any white smoke coming out of the tailpipe? When was the last time the cooling system had some cleaner run thru and flushed? How about a new oem thermostat? If your heater is blowing hot air I figure that the system is working with no trapped air. Steven. Link to comment Share on other sites More sharing options...
spooln30 Posted March 3, 2013 Share Posted March 3, 2013 If your heater core was bad you would have coolant inside your car on the carpets and you would have a sweet smell along with all of the windows would have a film of coolant on them. Probably the headgaskets GL. Link to comment Share on other sites More sharing options...
pleaidestar Posted March 3, 2013 Share Posted March 3, 2013 +1 monkeyposeur, if it gets hot sitting still and goes to normal operating temp when you drive normally there is air in your system. Burping it is real easy.... Let your car idle for a minute then take that plastic screw out of the passenger side of the radiator and take off the radiator cap, top off the coolant like normal until you see a little bit of the coolant come out of the hole you removed that screw from, then put the screw and cap back in. Test drive it for a few blocks, if your still heating up do the process again. Link to comment Share on other sites More sharing options...
afixer Posted March 3, 2013 Share Posted March 3, 2013 How old is the water pump. I have actuly had the fins on the pump errode so bad that the pump moved very little water, but enough to circulate just not enought to keep it cool. Also are the fans coming on, could be the sensor. Just one out of the box thoughts to go with the obvious, t stat, head gasket ideas. Relatively new to the sub motors , but have been around a few others for a bit. Good luck with it, hope it works out. Link to comment Share on other sites More sharing options...
mailman Posted March 3, 2013 Share Posted March 3, 2013 I don't remember if it was the haynes manual or the owner's manual, but somewhere I read that only one fan comes on all the time and that the second fan is an aux. that only comes on with the AC system. In my 96 the AC is broken and I've never had to use it, but I only ever have one fan. However, I noticed that on the 94, both of the fans run when they kick on (AC off). Which is it? Link to comment Share on other sites More sharing options...
subadoo_95 Posted March 4, 2013 Share Posted March 4, 2013 if eveything checks out fine,than chances are ur headgasket is on its way out. Link to comment Share on other sites More sharing options...
subadoo_95 Posted March 4, 2013 Share Posted March 4, 2013 I don't remember if it was the haynes manual or the owner's manual, but somewhere I read that only one fan comes on all the time and that the second fan is an aux. that only comes on with the AC system. In my 96 the AC is broken and I've never had to use it, but I only ever have one fan. However, I noticed that on the 94, both of the fans run when they kick on (AC off). Which is it? i have a 95 and only 1 fan works when needed.during ac the other one kicks in when needed as well.as long as the t-stat is doing its job there is no need for a fan to run all the time.i had this issues before and replaced one of the fittings thats under the throttle body and that fixed the problem..cant remember what its called Link to comment Share on other sites More sharing options...
Mitchael Posted March 5, 2013 Author Share Posted March 5, 2013 Thanks all! I'll try burping it. There's no smoke or milky film in the fluid. It was flushed a couple months ago, and the fans work just fine, when it heats up and when the AC runs. Link to comment Share on other sites More sharing options...
mailman Posted March 6, 2013 Share Posted March 6, 2013 Be patient with it... mine has been overheating only when ~2 hours into the mail route. Today when it happened I tried burping it and it kept the temperature down, but then I noticed that my heater only blew hot when accelerating. Eventually it overheated again, and so I burped it again. Same thing. Third time, I removed the plug too soon and coolant spit in my face Fourth time, I took my time, opened everything, ran it until it started spitting up, let it cool, did it again, then filled VERY slowly until the bleeder holes and under the cap were full and had no obvious air bubbles coming out. Sealed everything up, and it got me through the rest of the route. BUT, I'm still not confident that I did it right so tomorrow I have the day off and will do a "dry run" to see if I can get it to overheat again. I never want to see antifreeze again in my life Link to comment Share on other sites More sharing options...
snederhiser Posted March 7, 2013 Share Posted March 7, 2013 Hello; Subaru has a reverse system, the intake hose is on top and the return line is on the bottom of the radiator. Reason for the cooling system to be full and no air. Steven. Link to comment Share on other sites More sharing options...
jdm0305 Posted March 13, 2021 Share Posted March 13, 2021 thanks for the info new to my 98 never had problem with heating when changed timing belt and pulled rad 225,000 on my daughters legacy 2.5 gt my bad did not put overflow back in was this way 2 years but started over heating this spring and really thought was head gasket till i burped it and of course replace coolant over flow burped it was fine but simulated by blocking off fan an reving to 2500 at times and never over heated Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now