Destroyer_of_worlds Posted May 14, 2009 Share Posted May 14, 2009 ej22 out of a 1990 subaru legacy just replaced the head gasket and now i have this problem any ideas before i pull the engine again? Link to comment Share on other sites More sharing options...
987687 Posted May 16, 2009 Share Posted May 16, 2009 I know it seems obvious, but are you sure it is full of coolant? It takes a bit more than you'd think. Link to comment Share on other sites More sharing options...
Destroyer_of_worlds Posted May 20, 2009 Author Share Posted May 20, 2009 yeah i made sure twice but thank you Link to comment Share on other sites More sharing options...
Platinum_Racing Posted May 22, 2009 Share Posted May 22, 2009 Did you clean the old gasket material off the deck of the block before you replaced the gaskets? It's imperitive that you clean the deck before putting on new gaskets. I also trust that you torqued the head bolts to factory specs? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.