bookem288

Get you some raptor headers. Then high flow cats and high flow resonator. And then if you get it tuned you can get your pops Sent from my SM-G970U using Tapatalk

No, I wanted to replace it with a blue silicone hose.

Im looking to replace my pcv valve hose on a 3.6R motor and was wondering if any new what size hose fits on the PCV Valve.

Could it be grounding out on the connections at the tail light or the big gray connector?

Was this a direct bolt on? Also what part number for the Cadillac pistons?

Where did you guys ended up mounting your gauge and control panel?

I have. I went with 50%. I have no issues with eyesight. If you go darker then it may be an issue.

Ok, That is probably why I could find it on my car. Odd that I found it for a 2016 Legacy but maybe it is for the 2.5l

Has anyone removed the plastic intake manifold on their H6 for painting?

Has anyone had any luck with this for the 3.6R?

This one works too. Stahlbus Oil Drain Valve Plug M16x1.5x12mm Steel M16 x 1.5 x 12mm

Does this fit for a 2016 3.6r?

I had that happened too. It was the rubber curtain that came out of its track when the sunroof slid back to the open position. It was easy to put back in.

Do you have a part number for the air intake kit? I wanted to see if they have them in blue.

Good question that was why I was asking if anyone did put one in.

Has any replace the factory Low Beam HID bulb with an aftermarket one? If so how do you get to the bulb to replace it?

Has anyone added a pitch stop mount to their 3.6R legacy?

I was curious if anyone loaded a 2 step map for exhaust popping?

On my 2016 3.6R limited, My center screen does not show TPMS. It may show up on the NAVI screen under eco monitor.

So I finally added raptor headers, hi flow cats and 2.5 inch stainless steel piping going to the 5 inch axle back Nameless mufflers. I have deleted the stock resonator. So far it is much louder and has some rasp to it. I'm on the fence about adding a Vibrant resonator. Some had suggested to do a muffler delete. I'm not sure about that. My goal is for more of a growl sound and also trying to be less restrictive in the exhaust. Any thoughts and opinions?

Has anyone installed the raptor hi flow MAF sensor?

I have also experience this with 38000 miles. I don't see any leaks and coolant levels have remained the same.

Ed wanted me to tune stock first. Then I will get the headers put on soon. He wanted to make sure I don't have any leaks after the header install.

So I began tuning my ecu and cvt with Xtreme Racing Tuning. I can say that my experience so far has been pretty good. I have being working with Edward and must say he is pretty knowledgeable and very helpful with this process. So far I am on my first version of the tune and already can tell a significant difference in shifting. I cant wait for some more tunes as I continue to log and refine my car.

Does anyone have a wiring diagram for the head light harness? I am trying to find which color wire is power and ground on the HID low beams.