mansugi

Actually, it does helps just by replying to this thread.

All of the above are great idea and suggestion.

My last resort is to pull every single fuse that I think related to the dashboard lighting. Hopefully the fuse is the culprit.

Thanks for your feedback.

The instrument lights on my 2015 Legacy is not lighting up. I just notice it today when driving to work is the dark hours due to daylight saving time and I can't adjust the temp dial or the radio volume.

These are all the buttons and switches all the left and right hand side of the steering wheel.

Is there a button or switch that I need to push to turn these lights off and on on the steering wheel ??

Thank you all.

I agree with you on that one.

This is one of those Winjet foglight kits. They are pretty much has universal fitting.

Subaru has the switch but that is for OEM light kit not after market light kit.

OK. What did the aftermarket vendor say? Unless explicitly stated otherwise, and assuming you ordered the right kit, vehicle compatibility is their responsibility.

 

They exist, therefore they must be available somewhere ... new or used.

 

N.B. I am adamantly opposed to hacking up perfectly good factory wiring ... ever.

Did contact both parties.

No OEM switches available for the the Subaru.

This is an aftermarket light kit. So be creative as far as wiring.

Hey everyone!

In the process of installing the Winjet Fog Light Kit into my 2015 2.5i Legacy and getting puzzled as to where can I find the pre-arranged fog light connector to connect to the new fog light switch. I plan to just use the existing wiring by splicing the bulb connector instead of running the whole new wires.

Under the panel.........There were only 3 switches wired - dimmer, rear hatch opener and off road. The rest of the slots are blank switches.

All the "blank" switch didn't have any wiring harness connected to it except one next to the dimmer but the harness connector is not the same as the switch that come with the light kit. I'm a little confused as to where I plug in the new fog light switch into the existing fog lamp switch connector.

Is that extra connector is for fog light?

If so....do I need to splice that harness to the new connector that comes with the light kit so it will fit with the new switch?

THANKS in advance!!