torquemonster

Probably not nrw

 

I think it might have been the car was parked there.

I haven't been on here a lot but I saw an 05 lgt silver exhaust rims bren rear license plate bracket on my street near Burncoat h.s. in worc.

Dark LGT in auburn mass by exit 10 around 7:10 only saw the back

 

I would say it was me but I'm in South Yarmouth!

Obp heading south on 395 around 8 a.m. I tried to wave. I have an 09 obp with bronze tsw's

I am digging the way your tieing the orange into your car. On the other hand it is way too bright for me. But its deff a good looking gen5!!

2010 SSM with tail light tints and rain visors lic plate started with 2007. I was in the superior oil van.

You need a 04-05 with stock diff on a 09. I have a 05 6 speed in my 08 with the stock diff and the 2.5i driveshaft.

 

04-05 doesn't have DCCD right? Does your 08 have si drive?

Ok guys after reading most of the thread im still curious. I have an 09lgt I'm guessing by reading this thread it is r160? Now on the first post it said if you have an +06sti trans, I can use my rear diff because of the 1:1 stepper? I just need dccd control, driveshaft from either a 2.5i or a spec b 6MT flywheel and clutch, 2005 STI front axle seals (recommended), 6MT shift linkage, 6MT shifter, 6MT slave cylinder, 6MT clutch fork? The car is stock with a brentune. When I bought it I could feel the clutch slip on the highway a little. Today I was on the highway doing about 60mph. I went to pass someone in 5th gear, once boost hit the clutch slipped all the way till redline. I put it in 4th and it did it again. So I know it on its way out and would rather get the swap I want when I start puling the trans out to do the clutch.

 

Thanks for the help!