busyychild

Has anyone tried to fit a removed trunk lid inside either the trunk itself or in the backseats of a 4th gen for transportation? Thinking about picking up a trunk from a junkyard but only have my ‘08 with fold down seats to transport it. Thanks!

What is the general consensus on the Mevotech version of these LCAs? I have read through this entire thread and it seems people are only having issues with the Ultra-Powers. My bushings and ball joints are in need of a change on my 08 SpecB. If the there is a quality bolt on option, I’ll take that over pressing bushings out.

Sold!

PM sent!

Just finished my install. Below is a simple breakdown of my setup: Dash Kits: H0017AG920 - JDM Single Din Cubby Kit H6217AG911 - JDM Double Din Kit (w/ i88 and i85 adapters) Electronics: Sony XAV-AX8000 Double Din halo style stereo (Single DIN install) Generic 7" Double Din Android stereo (Used only as a screen for BtSsm) Metra ASWC-1 VAG-COM KKL USB OBD2 Cable Android Software: BtSsm (Gauges Displayed: Boost, IAM, AFR, Coolant Temp, Fuel Correction, FLKC, FKC, Batt) Autostart and StaY! (Runs BtSsm on Android boot) * Winter wheels don't have TMPSs installed * Cubby info screen isn't plugged in. The OEM Nav loom doesn't have the plug for it. May install something more interesting there in the future

Sold

The opening of the bezel is larger than a double din, so it will fit. The included brackets are intended for an oversized Panasonic JDM GPS, not a traditional double din.

For sale are: 1. Subaru Legacy Spec B 4th Gen JDM Facelift Honeycomb Grille in great condition. 91122AG100 $250 Shipped within the US using Paypal 2. Set of brand new 2x Front and 2x Rear StopTech Stainless Steel Braided brake lines for Subaru Legacy models: 950.47005 - Front 950.47505 - Rear $130 Shipped within the US using Paypal Please confirm fitment for each set for your own vehicle: https://www.summitracing.com/parts/SPH-950-47005/applications https://www.summitracing.com/parts/SPH-950-47505/applications $350 shipped within the US using Paypal for both

For sale are used in great condition JDM Nav bezel 1x H0017AG932 - 119x180mm Comes with: Bezel Vent extensions JDM Nav Bracket Screws $75 shipped in the US

I did, was a difference of ~$500 between rebooting or replacing. YMMV though, I’d get in contact with your local dealer/specialty shop to hone in on a price

Update: Had another dealer look at it and the Tech identified that the front (summer) wheels were out of balance by 1oz each, but could not rule out the axles being the issue. Since the axles had to come out anyways I opted to have them replaced with OEM. I can report that I now have no vibration in the steering wheel. Confirmed this now with my summer and winter wheel setups. So what ultimately was the cause of the vibration, unsure. As a mitigating factor for future premature passenger side CV boot failure, I have a downpipe blanket. (Passenger side failed/ripped, driver side was leaking from the seal).

If you have an aftermarket DP I would suggest a downpipe blanket. Easy to install and remove (while still on vehicle) and has the double duty of protecting the axle boot.

Was under my car today and noticed that my Front Passenger side CV Axle inner boot was ripped and had spewed (some, most, all?) of its grease out on the garage floor. The Front Driver side inner boot is also leaking. (see photos) I don't know how long it's been torn, but I'm guessing it gave up the ghost within the last 100 miles as I did not seen any leaks the last time I had it up on a lift or any grease on my garage floor. A few Questions: 1. There is a little bit of play in all directions when I move both axles by hand. Is that normal? Could the torn/leaking boots be the cause of my steering wheel shaking? 2. How far/long can I drive with the passenger side CV Axle boot without grease and not cause further damage. I have an appointment with the dealer to take a look at it in two weeks (I'm picking my battles with this one, not wanting to do it myself) . Front Passenger Side Inner CV Axel Boot: Front Drivers Side Inner CV Axel Boot:

For sale are brand new radio/JDM HVAC wiring harnesses: - i88 JDM HVAC - 14 Pin Forward Harness with added pin 7 for "Illumination -" used by the i88/JDM HVAC console - Metra/Axxess ASWC-1 harness SOLD Sold as a packaged, will not separate.

For sale is a factory navigation and gauge display unit for 4th generation 05-09 Subaru Legacy / Outbacks. In great condition. Pulled from a 2008 Legacy SpecB with 50k miles on it. Price is $250 shipped Includes: - Navigation Display - Navigation DVD control unit - Dashboard bezel and vents - East and West Navigation Map DVDs - Drivers side underseat DVD unit mounting bracket - GPS Antenna / 1st 1/2 of the Antenna to DVD unit cable - 1st 1/2 of the Display to DVD unit cable Does not include: - Main wire/head unit looms - 2nd 1/2 of the Display to DVD unit cable - 2nd 1/2 of the GPS antenna to DVD unit cable SOLD