Jump to content
LegacyGT.com

stook2001

Members
  • Posts

    1
  • Joined

Everything posted by stook2001

  1. qikslvr, thank you very much for helping to pave the way for the rest of us. Based upon your work, I purchased an ebay vagcom cable a while ago and was able to log without issue. I am now trying to flash using version 1.29a of EcuFlash and running into problems. Here is the log of what I am getting in EcuFlash when I try to read the rom after selecting the 04 DBW STi, etc.: [00:03:43.500] Version 1.29.906 [00:03:43.500] 8 memory models read. [00:04:06.921] 305 ROM metadata models read. [00:04:06.921] checksum module "subarudbw" loaded. [00:04:06.937] flashing tool "wrx02" loaded. [00:04:06.937] flashing tool "wrx04" loaded. [00:04:06.937] flashing tool "sti04" loaded. [00:04:06.937] flashing tool "sti05" loaded. [00:04:06.937] flashing tool "mitsukernel" loaded. [00:04:06.953] flashing tool "mitsukernelocp" loaded. [00:04:06.953] flashing tool "mitsubootloader" loaded. [00:04:35.687] unable to open OpenPort device [ Serial ]. [00:04:35.687] unable to connect to vehicle interface. Any idea what the issue could be? I've tried both updated and non-updated EcuFlash definitions. I have verified that I am using the cable driver that you linked to in your OP. I have also verified that the baud rate is set correctly. The green connectors have been connected under the dash by the steering wheel. There is no flash block (I dont think) since this is on an '04 STi, which is drive by wire. I'd appreciate any advice that you could offer for how to solve this problem. Can't think of anything else to check! thanks!
×
×
  • Create New...

Important Information

Terms of Use