-
Posts
90 -
Joined
Content Type
Profiles
Forums
Gallery
Posts posted by jhig
-
-
If you did all of that and are still getting a misfire it's most likely the injector or you might have valve issues. Have them do a compression test and see what it comes in at.
-
I should note that I changed the injector and ignition coil during that 34k and the check engine light stayed off for roughly 3,000 miles with each part replacement and came back on again.
-
Getting the engine pulled tomorrow by the dealer as I either have a burnt valve or ring failure. I have been getting a cylinder misfire since about 70k and am at 104k now. I was at 10 psi in cylinder #2. Needless to say, I love this car but this seems to be a common problem and it's a MAJOR one! I won't be buying another Subaru after this I can guarantee you that!
-
Having a misfire in cylinder #2. I just replaced the injector as that seems the most common issue but its still running the same. It's shaky at idle and almost stalls when I stop once in a while. Any ideas what I should replace next? What is the IC?
-
I likey....
-
I tend to over analyze purchases, make sure I have a full plan and know all the pitfalls/speedbumps. My last vehicle setup was a lot of planning, but went very smoothly in build/install and people were shocked by sound quality and visual appearance, especially considering the investment made.
Right now your product is leading for my aux-in requirement, just doublechecking I had not missed anything.
I was one of the people that had the problem with the 12V interfering with my sat radio. Sebastien did fix it, however, there is still a pretty loud interference noise coming from the alternator and through the speakers and I don't know why. I have to keep the volume level on my sat radio pretty low and turn my HU volume up to 30-35 to listen to it. If I turn my sat radio volume up past the halfway point or so my speakers start popping. Apparently I am in the minority though. This means that my music has very little bass and I can't turn up songs that I like really loud. Sebastien did fix it free of charge, but it's still not perfect. It works great with an ipod though!
-
I installed my switch in the cigarrette lighter. It fits perfectly, looks good, and is by far the easiest way to install it.
-
As did I, I won't have time to install it this weekend though . I was praying to get it by Friday because of the holiday weekend but what can you do. I can't wait to get this puppy installed!
-
I must have this. PM sent.
Cylinder misfires or bad injectors, please post here.
in Warranty Issues & Problems
Posted
I did the same thing with my car and the misfire ended being a burnt valve. I had used BG 44K after replacing injectors, plugs and coils and it worked for about a month or so and the CEL came back again and ran worse than ever. I hope for your sake the 44K is a permanent solution because a burnt valve is a friggin' large expense.