SimplyBao

Westy, it just takes him a while. Just email him again. It took a few weeks to get mine as well.

I searched but oddly I can't find this specific issue in this thread....so pardon me if I missed it.

 

I did the install this weekend and it went smoothly but, my fault, I didn't test it before it was completely reassembled. I'm paranoid about electronics and have an aversion to firing things up until they area sealed and back in place.

 

The problem I'm having is that the right channel is barely audible. There is sound comming from it, but perhaps 1/10th (or less) the level of the left side. When I searched I found threads on the left side fading out, but not the right so I'm guessing the issue may not be the same.

 

Thanks in advance.

 

You'll need to go back in and check all your connections. It sucks, but that's what you'll need to do.

 

2. Tap the middle wire in the loom. It's the brown and white one. I recomend using a multi-meter just to be sure though.

 

 

Okay, so I'm assuming the Brown and white wire send a 12v signal to the the diodes that is being wired up correct? I'm just asking to make sure I'm looking for the right thing when I test it to make sure

 

I'm going to do this soon but I'm not going to solder or cut any wiring.....that's going to be my attempt.

I received it yesterday and installed it this morning. It works beautifully!!!! Thanks Jazzy!

Just ordered mine yesterday and I can't wait to install it!!! Did anyone else receive a shipping confirmation when you purchased it? I haven't seen any confirmation of my order other than my paypal receipt.....

 

Jazzy can you confirm my order? I ordered it from chaser501@yahoo.com